Plus de vues

Ing Engineering bender by Heemskerk Metaal


Soyez le premier à commenter ce produit


Disponibilité :En stock

✓Livraison gratuite à partir de 100€ ✓Garantie de remboursement sous 100 jours


This bender is designed to match the Record blade geometry but can be used for any other speedskating blades also, it comes with a flat and profiled wheel. Machining of the parts and assembly is done in the Netherlands at Heemskerk Metaal.

Ing Engineering bender by Heemskerk Metaal ne peut être commandé que par multiples de 1


Ronald van de Ing has designed this bender to accommodate the unique blade-steel geometry of the Cádo Motus Record blades. This bender enables you to control your force to bend the ultra-strong Reynolds 953, 853 or 525 tubes, which is required for accurate bending.

Together with this bender we supply a profiled and a regular wheel with matching blocks to support the blade. The profiled wheel is design to accomodate the Cádo Motus blades but will fit onto any other 16mm diameter tube also. The regular wheel and blocks are for preparation on the flat area of other blades than Cádo Motus.

This solid bender is machined in Holland and weights 2040g. The length of the lever is 22cm within a total dimension of 38x10x10cm.


Informations complémentaires

Alliage aluminium de la platine Non
Longueur du pont (mm) Non
Entre Axe de la chaussure Non
Matériaux utilisés Non
Composition de la platine Non
Thermoformage sur la chaussure Non
Degré de rigidité sur la chaussure Non
Blade steel Non


Rédigez votre propre commentaire

Vous commentez : Ing Engineering bender by Heemskerk Metaal

Quelle note donneriez-vous à ce produit ? *

  1 étoile 2 étoiles 3 étoiles 4 étoiles 5 étoiles